每次煮完菜后，先讓吸油煙機持續工作30秒-1分鐘，將殘留在空氣中的油煙水氣及未焚燒徹底的一氧化碳抽出屋外。
同時，趁著吸油煙機上還有余熱，用抹布將表面簡單擦拭一遍，就能夠輕松擦去沾在吸油煙機上的油污，常保潔凈不油膩。
2、石家莊油煙機清洗方法
1、洗潔精、食醋浸泡法。將扇葉拆下，浸泡在用2毫升洗潔精和50ml食醋混合的一盆熱水中，浸泡約15分鐘后，再用潔凈的抹布擦拭。油煙機的機身也用此溶液清洗，要注意將溶液溫度保持在60℃左右，去污效果才是*的。
2、高壓鍋蒸汽沖洗法。高壓鍋內放半鍋冷水，燒沸，待有蒸汽不斷排出時取下限壓閥，翻開抽油煙機將蒸汽水柱對準旋轉著的扇葉，因?yàn)楦邿崴羝粩鄾_淋扇葉，油污水就會循著排油槽流入廢油盒里。
3、將刷洗好的抽油煙機扇葉曬干后，涂上一層辦共用膠水，幾個月后將電扇葉上的油污成片撕下來，油污全沾在膠水層上，既便利又潔凈。
4、先在灶臺上鋪報紙，翻開抽油煙機的開關“預熱”扇葉兩分鐘，往抽油煙機的電扇上噴洗潔精，關掉油煙機，靜置三分鐘，再將60℃的熱水噴入油煙機的電扇內，再翻開開關，讓已溶解的油污滴到儲油盒中。
標簽：www.jiangtiao.cn
After each cooking, let the hoodsucker work continuously for 30 seconds to 1 minute, and take out the remaining fume, water and carbon monoxide in the air. At the same time, taking advantage of the residual heat on the hood, simply wipe the surface with a rag, which can easily wipe off the grease stains on the hood and keep it clean and not greasy. 2. Cleaning method of fan blade of oil-smoke suction machine 1. Cleaning detergent and vinegar soaking method. Remove the fan blades and soak them in a pot of hot water mixed with 2ml detergent and 50ml vinegar. After soaking for about 15 minutes, wipe them with a clean cloth. The fuselage of the lampblack machine is also cleaned with this solution. Attention should be paid to keeping the temperature of the solution at about 60 C. The decontamination effect is * 2. Steam washing method of high pressure pot. The pressure cooker is filled with half pot of cold water and boiled. When the steam is continuously discharged, the lower pressure limiting valve is removed. The hood is turned over and the steam column is pointed at the rotating fan blade. Because the high hot water steam continuously washes the fan blade, the oil and sewage will flow into the waste oil tank along the drainage tank. 3. After drying the fan blades of the scrubbed lampblack machine, apply a layer of common glue on them. After several months, tear off the oil stains on the fan blades. The oil stains are all on the glue layer, which is convenient and clean. 4. Spread newspapers on the kitchen table, turn on the switch of the hood and "preheat" the fan blades for two minutes, spray detergent on the fan of the hood, turn off the hood, stand for three minutes, then spray hot water at 60 C into the fan of the hood, turn on the switch, and let the dissolved oil drip into the oil storage box.
